SpeedyBee Flushing Oil + EZI kit - Combo

The Complete Engine Cleaning Solution Over time, every engine develops sludge, carbon deposits, varnish, and contaminants that remain inside the lubrication system. Most engine flush products perform only one stage of cleaning. The SpeedyBee 2-Step Professional Engine Flush Kit provides a complete cleaning process by combining two complementary products. Old engine oil can leave behind sludge, varnish, carbon deposits, and other contaminants inside the engine. Replacing the oil alone may not remove all accumulated residues. The SpeedyBee Professional Engine Flush Combo Kit combines: SpeedyBee Flushing Oil – 4 Litres EZI Engine Internal Flush – 300ml Both products are used together as one flushing mixture after the old engine oil and oil filter have been removed. The mixture circulates through the engine for approximately 15–20 minutes at idle, helping loosen and carry away contaminants before being completely drained and replaced with the correct new engine oil and a new oil filter.

Key Features:

▪ COMPLETE ENGINE FLUSH COMBO: Includes SpeedyBee Flushing Oil 4L and EZI Engine Internal Flush 300ml, designed to be added together as one professional flushing treatment.

▪ HELPS REMOVE INTERNAL CONTAMINANTS: Circulates through the lubrication system to help loosen sludge, varnish, carbon deposits, and accumulated residues.

▪ 15–20 MINUTE IDLE TREATMENT: Use after removing the old oil and filter. Install a new filter, add both products, and run the engine at idle only.

▪ PREPARES THE ENGINE FOR NEW OIL: Helps clean internal oil passages and components before adding the manufacturer-recommended fresh engine oil.

▪ COMPLETE SERVICE PROCEDURE: After flushing, drain the complete mixture, remove the flushing filter, install another new filter, and refill with fresh engine oil.

▪ FOR PETROL AND DIESEL ENGINES: Suitable for compatible passenger cars, SUVs, pickups, vans, and light commercial vehicles.

Directions for Use:
▪ Step 1 – Drain the Old Oil Warm the engine to normal operating temperature, switch it off, and completely drain the old engine oil. Remove and discard the used oil filter.
▪ Step 2 – Install a New Filter and Add Both Products Install a new compatible oil filter. Pour the full contents of: - SpeedyBee Flushing Oil 4L - EZI Engine Internal Flush 300ml into the engine together. Confirm that the combined volume is suitable for the vehicle’s engine oil capacity. .
▪ Step 3 – Run the Engine Start the engine and allow it to idle only for 15–20 minutes. Do not drive the vehicle and do not increase the engine speed during the flushing process.
▪ Step 4 – Drain and Refill Switch off the engine and completely drain the flushing mixture while it is still warm. Remove the filter used during the flushing process. Install another new oil filter and refill the engine with the vehicle manufacturer’s recommended engine oil. Check the oil level and inspect for leaks.
▪ Why the Process Uses Two New Filters The first new filter is installed before flushing so it can collect loosened sludge, deposits, and contaminants during the 15–20-minute cleaning process. After flushing, this filter is removed because it may contain the contaminants released from inside the engine.